My builds usually start with a simple idea and I work from there. This one started with a telescope. I built the body of the telescope out of regular plastic tubing. I added half of a resin cast gear that will be used as part of the mechanical control. The next two pieces are filter lenses that will be added on after all of the painting is done. Next I will start to figure out the mechanical controls and the support structure.
Off to the photos.
This project started as I had picked up the Undead Barrow King from Mammoth Miniatures to make into a statue as he was listed at 50mm high. I decided that I would try put him up on a pillar to give a bit more height and so it did not take up quite as much floor space on the game board. The plinth is constructed out of layers of foamex. After the pillar was constructed it had string set in superglue added to the corners to simulate some decorative stone work. I decided to try adding some textures to the surface. I used a gold shaping cup to press the round details into the surface and it simulated pebbles set in concrete pretty well. Next I used two different punches to set detail into some stencil board. This was cut to size and made into metal plates for added details. The base was detailed out with some plastic skulls, resin, plaster and 3d printed jars and plates. Lastly some tube candles, coins were punched out of stencil card and I used some mustard seeds to simulate limes.
Hope you like.
Details
I will be adding a few more small stowage but I have managed to zenith prime so you can see some details. Minus some details, it is ready to be painted.
I have not had much time due to real life obligations. Tonight I had a bit of time to work on my build.
The back end looked odd hanging out in space without any support and I needed some way for people to access the torso interior. I decided on building a set of stairs and put a unicycle wheel on a swivel mount behind it.
I was perusing Etsy looking at things that have nothing to do with my hobbies, as you do, and found a couple of interesting finds that might work for terrain.
First are a couple of stamp punches. They are for metal working and only put me out about seven pounds a piece. Initially I thought about using them on Foamex.
Some photos.
First, I tried it on Foamex.
As you can see they did not come out so well so I think it will need to be used on either Fimo or some other putty.
The second thing I picked up is a shot plate. They are used to make small pieces out of gold/silver for jewelry. If you are looking to pick one up they will run about twenty pounds for a single item and about ten pounds for each detail past that.
In this instance I used some green stuff though I could use some lead fishing weights. Using some vasiline to keep the green stuff from sticking to the mold I just pressed some into the details. Here are some photos.
Finished a few more details.
First is a cage attached to the exterior. I had some left over photo etched brass fencing from another project to use as the bars. The bottom comes off so I can paint the crow and can add a few more details. There is also a plaster cast box fitted to the panel next to it.
A Hirst arts barrel and another plaster cast box to the other side.
Some resin and plaster cast sacks to the top of the thorax.
Lastly some photos of the whole thing held together with some blue tack.
Finished detailing the interior of the abdomen and am now able to mount it on the body. The floor is cut but is is just a piece of card ATM so I did not add put it together in the photos.
Interior photos.
Photo mounted on the body.
